网课邦

当前位置:首页 > 网课答案 > 其他网课

其他网课

通信电路与系统(杭州电子科技大学)1463243443 中国大学MOOC答案2024版100分完整版

时间:2025-01-15 14:13:58 作者:暂无作者 浏览量:
内容页左侧

Chapter1 Introduction to Basic Knowledge of Communication Electronics Circuits 3月10日课前练习

1、 问题:What is the core of the transmitter?
选项:
答案: 【Modulator】

2、 问题:Which of the following circuits is not part of super heterodyne receiver
选项:
答案: 【Modulator】

3、 问题:FM radio signal belongs to which wave type
选项:
答案: 【VHF】

4、 问题:When the resistive load increases, the selectivity of LC parallel resonant circuit will be improved, but( )will be decreased.
选项:
答案: 【Pass band B0.7】

5、 问题:In the wireless communication system , the transmitter and receiver are both have oscillator circuits.
选项:
答案: 【正确】

6、 问题:The frequency of High frequency signal only from 3- 30MHz?
选项:
答案: 【错误】

7、 问题:The resonant frequency will be changed by adjusting the value of L and C.
选项:
答案: 【正确】

8、 问题:Quality factor Q reflects the frequency-selective characteristic of the circuit, which is also related with the bandwidth.
选项:
答案: 【正确】

9、 问题:When the operating frequency is greater than the resonant frequency, the LC parallel resonant circuit and the LC series resonant circuit are both capacitive.
选项:
答案: 【错误】

10、 问题:LC series resonant circuit and LC parallel resonant circuit both have frequency-selective function.
选项:
答案: 【正确】

11、 问题:When the operating frequency of LC parallel reasonant circuit is lower than the reasonance frequency, the whole circuit is inductive
选项:
答案: 【正确】

12、 问题:The larger the rectangular coefficient, the better the frequency-selective performance.
选项:
答案: 【错误】

13、 问题:Load and source resistor will affect the frequency-selective characteristic of the circuit.
选项:
答案: 【正确】

Chapter1 Introduction to Basic Knowledge of Communication Electronics Circuits 3月17日课前练习

1、 问题:Can both the signal source and the load be partially access to the LC circuit
选项:
答案: 【Yes.】

2、 问题:Which of the following impedance conversion circuits can both increase and decrease the load
选项:
答案: 【All of above】

3、 问题:What will happen when the load is connected directly to the LC parallel resonant loop
选项:
答案: 【Impedance unmatched;
Lower transmission power;
Lower transmitting efficiency;
Lower transmitting sensitivity】

4、 问题:Why the LC impedance transformation network will be used in the circuit
选项:
答案: 【Reduce the influence on quality factor Q;
Improving the selectivity】

5、 问题:Typically, the Q value is negatively associated with the access factor.
选项:
答案: 【错误】

6、 问题:By using impedance conversion networks, the operation frequency of LC reasonace circuits will not change.
选项:
答案: 【错误】

Chapter2 Radio Frequency Amplifiers 3月24日课前练习

1、 问题:In the communication circuit system, which one is not a nonlinear circuit
选项:
答案: 【high frequency small signal amplifier】

2、 问题:What is the power amplifier generally classified according to
选项:
答案: 【Conduction angle】

3、 问题:What status dose Class C amplifier work at
选项:
答案: 【On-off】

4、 问题:What’s the bias point of the C class power amplifiers
选项:
答案: 【Below the pinch-off】

5、 问题:If the input signal of the C class power amplifier is a sinusoidal signal, the collector current is :
选项:
答案: 【periodic cosine pulses】

6、 问题:The higher the conduction angle, the higher the efficiency.
选项:
答案: 【错误】

Chapter2 Radio Frequency Amplifiers 3月31日课前练习

1、 问题:Class C PA can realize
选项:
答案: 【All the above】

2、 问题:The collector current of the class C PA is the periodic cosine pulses, but the output voltage is a sinusoidal (or cosine) signal.
选项:
答案: 【正确】

3、 问题:Pout=PL.
选项:
答案: 【错误】

4、 问题:The load line of class C PA is the same with the low frequency PA.
选项:
答案: 【错误】